Monday When we figured out where and how the plates where going we found materials 2 Steps Taken to Reach Objective: Objective (s): We worked on barring plates to hold the axles up in the rear end List issues / Complications: 1 3 4 Got the cad drawing for the plates and sent them off Start on mock up to see how tall they have to and to find out where the holes go. Tuesday We found out that the engine isn’t getting enough power 2 Steps Taken to Reach Objective: Objective (s): Get the old formula car motor running and see what was wrong with it List issues / Complications: 1 3 4 Take the starter off new engine to put it on the old one We hooked it up to a battery and got the gas tank mounted Still doesn’t start or get enough power so we are going to send to jasper and see what they can do Wednesday Get the axles tacked in so that we can spin them within the diff 2 Steps Taken to Reach Objective: Objective (s): Worked on the rear end List issues / Complications: 1 3 4 Making spacers to fit the rear end diff so that it is level and works Thursday Get plates positioned so that the half shaft has enough room 2 Steps Taken to Reach Objective: Objective (s): Work on rear end List issues / Complications: 1 3 4 Cut axle so that we can get half shaft at the right length Friday Get curved bars and put them into position 2 Steps Taken to Reach Objective: Objective (s): Work on rear end List issues / Complications: 1 3 4 Get the t bar tacked up so that we can potion the curved bars